Volkswagen Golf Service & Repair Manual: Wiring harness and connector repairs
- General notes concerning repairs to vehicle electrical system
- Wiring harness repair set -VAS 1978
- Upgrade kit -VAS 1978/50-
- Wiring harness repair set -VAS 1978A-
- Release tool set -VAS 1978/35
- Special pliers with insert
- Release tools for contacts
- Assembly tools for single wire seals
- Wire strippers -VAS 1978/3-
- Hot air blower, 220 V / 50 Hz -VAS 1978/14-
- Crimping pliers -VAS 1978/1A
- Notes on repairs to airbag and belt tensioner wiring
- Repairs to CAN bus wiring
- Renewal of aerial wiring
- Repairs to wiring with cross sections up to 0.35 mm2
- Wiring open circuit with one repair position
- Wiring open circuit with two repair positions
- Preparing fibre optic cable
- Detaching fibre optic cable from cable harness connector
- Repair set, aerial cable VAS 6720
- Notes on repairs to contact housings and connectors
- Repairs to contacts in contact housings
- Fitting single wire seals
- Repairs to contact housings using cut and clamp technique
- Notes on releasing and dismantling contact housings
- Secondary locking element
- Primary locking element
- Round connector systems
- Flat connector systems
- Special connector systems
Connecting vehicle diagnostic tester Golf Model Year 1998 - 2003
–
Apply handbrake.
–
Vehicles with automatic gearbox, move selector lever to
position “P” or “N”.
...
General notes concerning repairs to vehicle electrical system
Caution
When batteries are disconnected and reconnected, the
procedure described in the workshop manual must be
st ...
Other materials:
Removing and installing ambient temperature sensor -G17
Note
The ambient temperature sensor -G17- is used for determining
the outside temperature and as a switch-on condition of the
auxiliary and supplementary heater via CAN bus.
–
Removing and installing ambient temper ...
Removing and installing lock carrier trim
Special tools and workshop equipment
required
Removal lever -80 - 200
Removing
Vehicles with towing bracket, saloon
...
Sensors
Removing and installing steering angle
sender -G85-
Note
The steering angle sender -G85- is a component of the
steering rack.
It cannot be renewed as an individual part.
...
