Volkswagen Golf Service & Repair Manual: Wiring harness repair set -VAS 1978

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Wiring / Wiring harness and connector repairs / Wiring harness repair set -VAS 1978

Wiring harness repair set -VAS 1978- allows optimal repair quality to be achieved in the area of vehicle electrics. Using the tools, repairs to connectors and wiring open circuits can be carried out. To do this, complete repair wire sections with contacts already crimped on are used and joined to the vehicle's own wiring harness with the aid of crimp connectors. A special set of pliers with three different crimp recesses and a hot air blower for shrinking the crimp connectors make a perfect electrical connection.

Note

Additional information:

→ Operating instructions Wiring harness repair setVAS 1978

Wiring harness repair set -VAS 1978

General notes concerning repairs to vehicle electrical system

Caution When batteries are disconnected and reconnected, the procedure described in the workshop manual must be st ...

Upgrade kit -VAS 1978/50-

Upgrade kit -VAS 1978/50- is required to bring the “old”wiring harness repair set -VAS 1978- up to the latest standard of wiring harness repair set -VAS 1978A-. T ...

Other materials:

Switching over headlights for driving abroad (travel mode)
First read and observe the introductory information and safety warnings If you have to drive a right-hand drive vehicle in a left-hand drive country, or vice versa, the asymmetric dipped beam headlights may dazzle oncoming traffic with xenon headlights. Therefore, the headlights must be sw ...

Removing and installing trim panel
Note Removal and installation are described for the trim panel on driver side. Follow same instructions for the front passenger side as appropriate. Removing – Remove rear door trim ...

Overview of fitting locations
Overview of fitting locations - ABS/ESP 1 - ABS control unit -J104- Installation location: on hydraulic unit, on passenger side in engine compartment. Do not separate connector before successfully completing self-diagnosis. Switch ...