VW Golf manuals

Volkswagen Golf Service & Repair Manual: Crimping pliers -VAS 1978/1A

Crimping pliers -VAS 1978/1A- or crimping pliers (base tool) -VAS 1978/1-2- together with head adapter 0.35 - 2.5 mmІ -VAS 1978/1-1- or head adapter 4.0 - 6.0 mmІ -VAS 1978/2A- are used to squeeze together crimp connectors from the wiring harness repair sets.
Crimping connectors using crimping pliers -VAS 1978/1A- → Chapter.
The following heads adapters are available for crimping pliers (base tool) -VAS 1978/1-2-:
Head adapter 0.35 mm2 - 2.5 mm2 -VAS 1978/1-1-
Head adapter 4.0 mm2 - 6.0 mm2 -VAS 1978/2A-
Head adapter for JPT contacts -VAS 1978/9-1-
In conjunction with head adapter for JPT contacts -VAS 1978/9-1-, the crimping pliers are used to crimp contacts to single wires during repairs to wiring with cross sections up to 0.35 mm2 → Chapter.
Interchanging head adapter:
–  Open up the crimping pliers fully.
 

Crimping pliers -VAS 1978/1A

–  Unclip both locking pins -arrows- from the body of the crimping pliers.
 

Crimping pliers -VAS 1978/1A

–  Insert the required head adapter from above -arrow- in the body of the crimping pliers.
 

Crimping pliers -VAS 1978/1A

–  Lock the head adapter by engaging the pins -arrows- in the body of the crimping pliers.
 

Crimping pliers -VAS 1978/1A

Hot air blower, 220 V / 50 Hz -VAS 1978/14-
  Caution When shrink-fitting, take care not to damage any other wiring, plastic parts or insulating material with t ...

Notes on repairs to airbag and belt tensioner wiring
In addition to the general notes on repairs to wiring harnesses, the following instructions must be observed on how to repair wiring in airbag and belt tensioner syst ...

Other materials:

Distinguishing features of jointless wiper blades
Distinguishing features of Bosch and Federal Mogul products. When renewing wiper rubbers, note the make. When renewing wiper blades, the same make must be used. Wiper blades can be identified according to wiper arm ...

Renewing trim elements, bolted trim elements
These wheels are fitted with exchangeable trim elements. Follow these instructions during installation.     –  Clean the thread in the wheel before screwing in the new bolts. ...

Separating control unit from hydraulic unit
Special tools and workshop equipment required ESD workplace -VAS 6613- Torx bit T25 If a control unit is defective, separate it from the hydraulic unit and renew only the control ...

© 2016-2026 Copyright www.vwgolf.org