Volkswagen Golf Service & Repair Manual: Front seats
- Overview of fitting locations - electrical and electronic components, standard seat, seat of type "ergo Aktiv"
- Overview of fitting locations - electrical and electronic components, electrically adjustable seat
- Assembly overview - backrest release mechanism and entry assistance
- Assembly overview - front backrest
- Assembly overview - seat pan
- Assembly overview - fire extinguisher
- Removing and installing front seat
- Removing front seat if seat longitudinal adjustment motor -V28-/-V31- is defective
- Connecting and disconnecting airbag adapter
- Removing and installing seat trim on tunnel side
- Removing and installing seat trim on sill side, seat of type "ergo Aktiv"
- Removing and installing seat trim on sill side, standard seat
- Removing and installing seat trim on sill side, electrically adjustable seat
- Removing and installing front backrest
- Removing and installing seat depth adjustment
- Removing and installing handle for seat height adjustment
- Removing and installing lower seat pan frame with seat longitudinal adjustment motor -V28-/-V31-
- Removing and installing lumbar support adjustment
- Removing and installing head restraint
- Removing and installing head restraint guide
- Removing and installing trim for backrest release mechanism
- Removing and installing backrest release mechanism
- Removing and installing connecting Bowden cable
- Removing and installing mounting bracket for backrest release mechanism
- Removing and installing Bowden cable for backrest release
- Adjusting Bowden cable for backrest release mechanism
- Removing and installing easy-entry Bowden cable A
- Adjusting Bowden cable A for entry assistance
- Removing and installing Bowden cable B for entry assistance
- Removing and installing memory block
- Removing and installing storage compartment
- Removing and installing lumbar support adjustment switch -E176-/-E177-
- Removing and installing lumbar support adjustment motor -V125-/-V126-/-V129-/-V130-
- Removing and installing seat adjustment operating unit -E470-/-E471-
- Removing and installing massage control unit -J740-
Mounting front seat on seat repair stand
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
&n ...
Overview of fitting locations - electrical and electronic components,
standard seat, seat of type "ergo Aktiv"
1 -
Massage control unit -J740-
Removing and installing
→ Chapter
Depends on equipment
2 -
Seat heating element
Hea ...
Other materials:
Removing and installing fuel delivery unit/fuel gauge sender, vehicles with
front-wheel drive
Special tools and workshop equipment
required
Wrench -T10202-
Torque wrench -V.A.G 1332-
...
Factory fitted towing attachment
If the vehicle was supplied with a factory fitted towing
attachment, everything with regards to the technical and legal
requirements has already been taken care of.
It should be noted that from the start of 1988 a
»13-pin« trailer socke ...
Sockets in the vehicle
Fig. 125 In the rear section of the centre
console: 12-volt socket
Fig. 126 In the luggage compartment: 12-volt
socket
First read and observe the introductory information
and safety warnings Maximum power rating
Electrical socket
Maximum power rating
...
