Volkswagen Golf Service & Repair Manual: Removing and installing mounting bracket for backrest release mechanism
| Special tools and workshop equipment
required |
|
|
|
| |
Special pop rivet pliers -V.A.G 1753B- |
| – |
Remove backrest cover and backrest padding
→ Chapter. |
| – |
Remove connecting Bowden cable
→ Chapter. |
WARNING
|
|
|
|
| – |
Push Bowden cable end-piece -1-
in -direction of arrow- off
mounting bracket for backrest release mechanism using a
screwdriver. |
| – |
Drill out rivet -2- on backrest
frame. |
| – |
Remove mounting bracket for backrest release mechanism
-3- from backrest frame. |
| Installation is carried out in reverse order. |
| |
→ Chapter „Assembly overview - front backrest“ |
| |
→ Chapter „Assembly overview - front seat“ |
|
|
|
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
...
Note
The left and right Bowden cables cannot be renewed
individually.
Special tools and workshop equipment
required
...
Other materials:
Run-flat tyres, repair work
WARNING
Tyres with run-flat properties must be replaced
after they have been run deflated.
Adhere to the special assembly instructions
→ Chapter.
...
Outer shoulder wear
Unsuitable use of self-levelling adjustments on pneumatic
suspension system
The use of the offroad level is recommended only for driving
offroad. Permanent use of the offroad level during normal road
operation can lead to increased tyre ...
Removing and installing relay and fuse carrier behind dash panel, LHD
vehicles
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
–
Remove dash panel
→ General body repairs, interior; Rep. gr.70.
...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing connecting Bowden cable
Removing and installing Bowden cable for backrest release