Volkswagen Golf Service & Repair Manual: Interior trims
- Assembly overview - sill panel moulding
- Assembly overview - A-pillar trim
- Assembly overview - B-pillar trim
- Assembly overview - D-pillar trim
- Assembly overview - side trim panel
- Assembly overview - wheel housing trim, saloon
- Assembly overview - wheel housing trim, estate
- Assembly overview - foot rest and floor covering, LHD vehicles
- Assembly overview - foot rest and floor covering, RHD vehicles
- Removing and installing sill panel moulding, 2-door model
- Removing and installing sill panel moulding, 4-door model
- Removing and installing A-pillar gap cover
- Removing and installing A-pillar trim
- Removing and installing B-pillar trim, 4-door models and estate
- Removing and installing B-pillar trim, 2-door models
- Removing and installing C-pillar trim, saloon
- Removing and installing C-pillar trim, estate
- Removing and installing D-pillar trim
- Removing and installing side trim panel
- Removing and installing wheel housing trim, saloon
- Removing and installing wheel housing trim, estate
- Removing and installing floor covering
Removing and installing dash panel central tube
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
...
Assembly overview - sill panel moulding
Note
The illustration shows the sill panel moulding on the left side. The
right-hand side is similar (mirror image of left-hand side).
I: sill panel moulding, 4-door ...
Other materials:
Indicator lamps and fuel gauge
Fig. 187 In the instrument cluster: fuel
gauge for petrol and diesel
First read and observe the introductory information
and safety warnings 
Lit up
Needle position
 
Possible cause  
Solution
Red mark ...
Removing and installing door opener illumination bulb -L108-/-L109-
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way (mirror image of left side).
Removing
–
Remove front ...
Removing and installing onboard supply control unit -J519-, RHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
â ...
