Volkswagen Golf Service & Repair Manual: Assembly overview - foot rest and floor covering, RHD vehicles
| 1 - | Foot rest |
- Removing and installing → Chapter
| 2 - | Bolt |
- 2 Nm
| 3 - | Nut |
- Qty. 3
- 2 Nm
| 4 - | Bracket |
- Removing and installing → Chapter
| 5 - | Floor covering |
- One-piece design.
- Removing and installing → Chapter „Removing and installing floor covering“
Assembly overview - foot rest and floor covering, LHD vehicles
1 -
Foot rest
Removing and installing
→ Chapter
Must fully engage into bracket.
2 -
Nut
Qty. 3
2 Nm
...
Removing and installing sill panel moulding, 2-door model
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
...
Other materials:
Removing and installing rear left vehicle level sender -G76-, torsion beam
axle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
Connecting vacuum gauge for brake servo -VAS 6721-
Special tools and workshop equipment
required
Vacuum gauge for brake servo -VAS 6721-
–
Pull vacuum hose out of brake servo.
First press the br ...
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
