Volkswagen Golf Service & Repair Manual: Control motors
- Overview of fitting locations - front control motors, air conditioning system with electric/manual controls, LHD vehicles
- Overview of fitting locations - front control motors, air conditioning system with electric/manual controls, RHD vehicles
- Overview of fitting locations - front control motors, Climatronic, LHD vehicles
- Overview of fitting locations - front control motors, Climatronic, RHD vehicles
- Removing and installing temperature flap control motor -V68-, LHD vehicles
- Removing and installing temperature flap control motor - V68-, RHD vehicles
- Removing and installing defroster flap control motor -V107- with potentiometer -G135-, LHD vehicles
- Removing and installing defroster flap control motor -V107- with potentiometer -G135-, RHD vehicles
- Removing and installing air recirculation flap control motor -V113-, LHD vehicles
- Removing and installing air recirculation flap control motor -V113-, RHD vehicles
- Removing and installing left temperature flap control motor -V158-, LHD vehicles
- Removing and installing left temperature flap control motor -V158-, RHD vehicles
- Removing and installing right temperature flap control motor -V159-, LHD vehicles
- Removing and installing right temperature flap control motor -V159-, RHD vehicles
- Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, LHD vehicles
- Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, RHD vehicles
- Removing and installing front air distribution flap control motor -V426-, LHD vehicles
- Removing and installing front air distribution flap control motor -V426-, RHD vehicles
- Removing and installing air distribution flap control motor -V428-, LHD vehicles
- Removing and installing air distribution flap control motor -V428-, RHD vehicles
- Removing and installing front air distribution flap actuation unit, heater and air conditioning system with electric/manual controls, LHD vehicles
- Removing and installing front air distribution flap actuation unit, heater and air conditioning system with electric/manual controls, RHD vehicles
- Removing and installing front air distribution flap actuation unit, Climatronic
- Removing and installing front air distribution flap actuation unit, Climatronic, RHD vehicles
Removing and installing Sanden belt pulley
Note
The pulley is sensitive to impact and should therefore be
treated with extreme care.
If the belt pulley overload prot ...
Overview of fitting locations - front control motors, air conditioning
system with electric/manual controls, LHD vehicles
1 -
Temperature flap control motor -V68-
With potentiometer for temperature flap control motor -G92-.
Checking: with vehicle diagnostic tes ...
Other materials:
Removing and installing lower steering column trim
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Remove upper steering column trim
→ Chapter.
...
Seam seals, body of CNG-powered vehicles
Note
Seam seals made during repair work must be identical in
appearance and thickness to the original seam seals.
To avoid damage or faulty operation, brush seam seals smooth
near attachments which must be attached.
...
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
...
