Volkswagen Golf Service & Repair Manual: Removing and installing Sanden belt pulley
 Note
| The pulley is sensitive to impact and should therefore be
treated with extreme care. |
| If the belt pulley overload protection has deployed, check
freedom of movement of air conditioner compressor before
renewing belt pulley. If air conditioner compressor cannot
rotate freely it must be renewed. |
| If the drive plate overload protection device has been
triggered, the pulley can rotate with the outer section of the
drive plate without the air conditioner compressor shaft and the
hexagon flats attached to the drive plate (inner section of
drive plate) also rotating. |
| – |
Remove poly V-belt
→ Rep. gr.13. |
| – |
Removing and installing belt pulley
→ Chapter. |
|
|
|
Note
The pulley is sensitive to impact and should therefore be
treated with extreme care.
If the belt pulley overload prot ...
Other materials:
Removing and installing suction-jet pump
On vehicles with four-wheel drive the fuel tank is divided
into a left and a right chamber. A suction-jet pump
-2- is used for delivering fuel
from the left fuel tank chamber to the baffle housing of the
fuel delivery unit -1- on the
right.
...
Rear brakes
Rear brakes FNc-M38 (15”):
Item
PR No.
1KE / 1KV
1
Brake caliper
FNc-M38 (15”)
2
Brake pad,
thickness
mm
11
Brake pad, wear limi ...
Incorporation of high-voltage heater (PTC) - Z115- into coolant circuit
Note
In vehicles with a high-voltage system, the high-voltage
heater (PTC) -Z115- is used as a supplementary heater.
In vehicles with a high-voltage system and an auxiliary
heater installed as optional equipment, the ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing Denso belt pulley
Control motors