Volkswagen Golf Service & Repair Manual: Lights
- Overview of fitting locations – lights in dash panel
- Overview of fitting locations – lights in front doors
- Overview of fitting locations – lights in rear doors
- Overview of fitting locations – lights in centre console
- Overview of fitting locations – lights in roof trim
- Removing and installing glove compartment light -W6-
- Renewing bulb for glove compartment light -W6-
- Removing and installing front footwell light -K268-, driver side
- Removing and installing front footwell light -K269-, front passenger side
- Removing and installing front footwell illumination bulb -L151-/-L152-
- Removing and installing central locking SAFELOCK function warning lamp -K133
- Removing and installing front entry light -W31-/-W32-
- Removing and installing door opener illumination bulb -L108-/-L109-
- Removing and installing selector lever position display -Y26-
- Removing and installing luggage compartment light -W3-
- Removing and installing illuminated vanity mirror -W20-/-W14-
- Removing and installing light for front interior light -W1- with LED
- Removing and installing bulb for front interior light -W1- with incandescent bulbs
- Removing and installing bulb for rear interior light -W43- with incandescent bulbs
- Removing and installing light for rear interior light -W43- with LED
- Removing and installing light conductor for front sill panel moulding ambient lighting -W67-/-W68
Overview of fitting locations – lights in dash panel
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Front passenger side airbag d ...
Other materials:
Installing brackets for parking aid system
Special tools and workshop equipment
required
Installation tool for PDC bracket -VAS 6614-
Materials
Cartridge gun ...
Balancing wheel, balancing wheel on stationary wheel balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Connecting brake pedal to brake servo
Hold ball head of plunger rod in front of mounting and push
brake pedal in direction of brake servo, so that the ball head
clicks into place.
–
Check engagement by pulling briefly on brake pedal.
...
