Note| The illustration shows fitting locations for LHD vehicles. Fitting locations for RHD vehicles are similar. |
| 1 - | Selector lever position display -Y26- |
| Removing and installing → Chapter |
| Overview of fitting locations – lights in luggage compartment |
| 1 - | Luggage compartment light -W3- |
| In luggage compartment side trim (right side) |
| Removing and installing → Chapter |
Overview of fitting locations – lights in rear doors
Overview of fitting locations – lights in roof trimWithout needing to purge refrigerant circuit of contaminants (e.g. damage in
an accident); no refrigerant has escaped and no moisture or dirt has entered
refrigerant circuit
Drain refrigerant circuit.
–
Renew restrictor. Depending on vehicle
–
Remove receiver or reservoir.
–
Clean any dirt out of receiver or reservoir.
...
Corrosion protection for body components, add-on components and welded
components
Attachments
Wings, doors, covers and flaps must be coated completely on
the inside as well. One wet-in-wet spray pass is adequate for
this.
Before installing, add-on parts must be sealed with cav ...
Starting conditions for auxiliary heater, supplementary heater mode
Terminal 15 (ignition) on
Engine speed > 600 rpm
Coolant temperature < 72 °C
Ambient temperature < 5 °C
Reserve fuel level not reached
...