Volkswagen Golf Service & Repair Manual: Lights, lamps, switches inside, anti- theft system

Calibrating Blind Spot Monitor control unit -J1086-/-J1087-

  Note Before the actual calibration process of the control units, the calibration unit -VAS 6350- needs to be set up as described in the following chapt ...

Lights

...

Other materials:

Removing and installing emblem with model designation, “R”
Special tools and workshop equipment required         Torque wrench -V.A.G 1783-   Note Only remove when radiator grille -3- is removed. Removing ...

Incorporation of heat exchanger for high-voltage battery into coolant circuit of high-voltage system
  Note Fill coolant and bleed coolant circuit → Rep. gr.19. The illustration below shows only some of the components of the coolant circuit for the high-voltage system. For components which are not sho ...

Assembly overview - drive shaft, triple roller joint AAR3300i
1 -  Bolt Renew after removing Loosening and tightening → Chapter Before fitting, clean the threads in the CV joint using a thread tap. 200 Nm +180° 2 -  ...