Volkswagen Golf Service & Repair Manual: Controls
- Overview of fitting locations – controls in dash panel
- Overview of fitting locations – controls in front doors
- Overview of fitting locations – controls in rear doors
- Overview of fitting locations – controls in centre console
- Overview of fitting locations – controls in roof trim
- Removing and installing rotary light switch -EX1-
- Removing and installing headlight range control regulator -E102-
- Removing and installing switch module in centre console -EX23-/-EX30-
- Removing and installing hazard warning light switch -EX3-
- Removing and installing glove compartment light switch -E26-
- Removing and installing exterior mirror adjuster -EX11-
- Removing and installing operating unit for window regulator in driver door -E512-
- Removing and installing front passenger side window regulator button -E716-
- Removing and installing driver side interior locking button for central locking system -E308-
- Removing and installing fuel tank flap release button -E319-
- Removing and installing button for deactivating interior monitoring and vehicle inclination sensor -E616-
- Removing and installing rear window regulator switch in door -E52-/-E54-
- Removing and installing electromechanical parking brake button -E538-/auto-hold button -E540-
- Removing and installing the starter button -E378-
- Removing and installing sunroof button -E325-
- Removing and installing front interior light/reading light
- Removing and installing rear interior light/reading light
- Removing and installing front right reading light button -E634-
Removing and installing light conductor for front sill panel moulding
ambient lighting -W67-/-W68
Note
The light conductors for front sill panel moulding ambient
lighting -W67-/-W68- are integrated into the sill panel
mouldings and cannot be r ...
Overview of fitting locations – controls in dash panel
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Hazard warning light switch - ...
Other materials:
Overview - drive shaft
I -
→ Chapter „Assembly overview - drive shaft, constant velocity joint
VL100“
II -
→ Chapter „Assembly overview - drive shaft, constant velocity joint
VL107“
III -
→ Cha ...
Changing headlights over from driving on right to driving on left, LED
headlights
If a right-hand drive vehicle is driven in a left-hand drive
country, or vice versa, the headlights must be converted. This
is necessary in order to avoid dazzling oncoming traffic with
the asymmetric low beam headlights.
Note
...
Removing and installing turn signal bulb
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
Removing
–
Remove tail light cluster on body
& ...
