Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...
Dismantling and assembling drive shaft, constant velocity joint VL107
Special tools and workshop equipment required
Thrust plate -VW 401-
Thrust plate -VW 402-
Press tool -VW 408 A-
Support sleeve -VW 522-
Tensioner -40 - 204 A-
Special pliers -V.A.G 1682 ...
Assembly overview - axle beam
1 -
Cover
2 -
Bolt
Renew after removing
50 Nm +45°
3 -
Bolt
Renew after removing
Tighten in unladen state
→ Chapter.
...