Overview of fitting locations - storage compartments/coversAssembly overview - suspension strut, shock absorber, spring, torsion beam
axle
1 -
Bolt
Renew after removing
50 Nm +45°
2 -
Shock absorber
Removing and installing
→ Chapter
Defective shock absorbers must always be degassed and drai ...
Removing and installing inlet camshaft oil seal, pulley end, engine codes
CPTA, CHPA, CZEA, CZDA
Special tools and workshop equipment
required
Assembly tool -T10478 B-
Removing
–
Detach toothed belt from camshafts
→ Chapter ...
Main beam assist
First read and observe the introductory information
and safety warnings Main beam assist (Light Assist)
Within the limits of the system, the main beam assist automatically switches
the main beam on at speeds of over approximately 60 km/h (37 mph), depending on
environmental and traffic con ...