Volkswagen Golf Service & Repair Manual: Test preparations, wheel alignment with driver assist systems

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Wheels, tyres, axle align / Wheel alignment / Test preparations, wheel alignment with driver assist systems

The following steps are required if one or more driver assist systems on the vehicle are to be calibrated via the “Quick-start” procedure (i.e. without first checking and adjusting the wheel alignment):

Before driving the vehicle onto the alignment platform, make sure there is sufficient space between the vehicle and the calibration unit. The distance between the calibration unit and the vehicle must be 120 cm ± 2.5 cm.

If the available space is not adequate, move the vehicle backwards on the alignment platform as required. This allows the use of the respective floor area.

Before starting calibration, read out event memory and rectify any faults.

Vehicle accurately aligned, suspension bounced and rocked several times.

When checking wheel alignment, ensure that sliding plates and turn tables are not touching end stop.

Connect battery charger → Vehicle electrics; Rep. gr.27.

Move front wheels to straight-ahead position.

Connect → Vehicle diagnostic tester to vehicle, route diagnostic cable through open door window.

Vehicle exterior lighting switched off.

All doors of vehicle are closed.

Press button to select required calibration on wheel alignment computer.

Test preparations, wheel alignment with no driver assist systems

Special tools and workshop equipment required Wheel alignment computer -V.A.G 1813F- or VW/Audi-approved wheel alignment units Brake pedal depressor ...

Specified values for wheel alignment, torsion beam axle, Golf

These specifications apply to all engines. Explanations regarding PR numbers → Chapter „Vehicle data sticker“. Front axle Basic ...

Other materials:

Checking holding pressure
Special tools and workshop equipment required Pressure tester -VAS 6550- Removal wedge -3409- Connector cable -VAS 6550/3-3- Connector cable -VAS 6550/3-4- Vehicle diagnostic tester ...

Lights, lamps, switches outside
Operation and safety notes for gas discharge bulbs – If repairs are to be made to the headlight with gas discharge bulbs, observe the following: Notes on dangerous high voltage/currents →& ...

Assembly overview - condenser
Condenser, receiver Note The illustration shows the Modine condenser. 1 - Condenser Different versions. Refer to → Electronic Parts Catalogue. Removing and installing → Cha ...