Volkswagen Golf Service & Repair Manual: Refrigerant circuit
- Assembly overview - condenser
- Removing and installing refrigerant circuit pressure sender -G805
- Removing and installing condenser
- Removing and installing damper weight for refrigerant line, low-pressure side
- Removing and installing evacuating and charging valves on low and high-pressure side
- Removing and installing refrigerant pressure and temperature sender -G395
- Removing and installing refrigerant shut-off valve for heater and air conditioner unit -N541
- Removing and installing refrigerant shut-off valve for high-voltage battery heat exchanger -N542
- Removing and installing heat exchanger for high-voltage battery
- Refrigerant line with restrictor
- Removing and installing refrigerant line between condenser and evaporator
- Removing and installing refrigerant line between condenser and air conditioner compressor
- Removing and installing refrigerant line between air conditioner compressor and evaporator
Overview of fitting locations - components inside of front passenger
compartment, RHD vehicles
1 -
Air recirculation flap control motor -V113- or fresh air/recirculated
air, air flow flap control motor -V425-
Removing and installing air recirculat ...
Assembly overview - condenser
Condenser, receiver
Note
The illustration shows the Modine condenser.
1 -
Condenser
Different versions. Refer to
&# ...
Other materials:
Brake test
General information
The drive is provided by the test rig.
For the test, ensure for vehicles with a manual gearbox that
the gear lever is in neutral, and for vehicles with an automatic
gearbox that the select ...
Assembly overview - rear door trim
Note
The assembly overview is shown for the rear door trim on driver
side. The assembly overview for the front passenger side is analogous.
1 -
Door trim
Removing and installing
→ Chapter
2 -
Rear d ...
Removing and installing trim for locking mechanism
Special tools and workshop equipment
required
Removal wedge -3409-
Hook -T10538-
Removing
Note
...
