Volkswagen Golf Service & Repair Manual: Door components
- Assembly overview - door components
- Assembly overview - window regulator
- Assembly overview - door handle and door lock
- Removing and installing window regulator motor -V26-/-V27
- Removing and installing window regulator
- Removing and installing window winder
- Removing and installing inner door cover
- Removing and installing striker pin
- Removing and installing cap
- Removing and installing door handle
- Removing and installing mounting bracket
- Removing and installing door lock
- Removing and installing window channel
- Removing and installing window slot outer seal
- Removing and installing window slot inner seal
Removing and installing door inner seal
During production, a sealant is applied to the door inner
seals, which are then placed on the door flange and rolled on.
Note
...
Assembly overview - door components
Note
Only the left side is shown. The right side is similar.
1 -
Rear door
Removing and installing
→ Chapter
Adjusting
&# ...
Other materials:
Removing and installing actuator
Removing
–
Removing tank flap unit
→ Chapter
–
To get access to connector, remove right luggage compartment side
trim
→ General body repairs, interior; Rep. gr.70
–
Separate ...
Removing and installing fuel tank flap release button -E319-
Special tools and workshop equipment
required
Removal wedge -3409-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and ins ...
Removing and installing accelerator module -GX2-
Removing
–
Fold floor covering -1-
forwards in -direction of arrow-.
–
Release and pull off connector -2-
...
