Volkswagen Golf Service & Repair Manual: Removing and installing cap
| Special tools and workshop equipment
required |
|
|
|
|
|
|
Assembly tool -T10389 |
| – |
Insert assembly tool -T10389- approx. 44 mm into the door behind
locking hook -2- of the door handle
bracket. |
| – |
Pull assembly tool -T10389- approx. 5 mm backwards
-arrow- until hook is detached. |
| – |
Pull door handle off door. |
| – |
Pull cover cap -1- out of door handle
bracket. |
| – |
Pull door handle -2- off door. |
| – |
Push cover cap -1- into door handle
bracket. |
| – |
Insert flat-bladed screwdriver -4-
approx. 40 mm into door handle bracket until locking hook
-3- is reached. |
| – |
Press cap -1- onto door. |
| – |
Push screwdriver approx. 5 mm into hole
-arrow- until hook locks in place. |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Note
Removal and installation are described only for the right
door handle. The right side is similar.
Removing
...
Other materials:
Recycling and refuse law
Note
The laws and regulations listed below are valid in the
Federal Republic of Germany. Other or additional laws and
regulations may apply in other countries.
Sources in other countries may be obtained from the
...
Rules for cleanliness
When working on the fuel supply and injection system,
observe the following “5 rules” for cleanliness:
Thoroughly clean all unions and surrounding areas before
disconnecting.
Place removed parts on a clea ...
Assembly overview - control units, LHD vehicles
1 -
Control unit
Versions with parking aid:
Parking aid control unit -J446-
Assembly overview
→ Chapter
Versions with park assist steering:
Park assist steering control unit -J791-
...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing striker pin
Removing and installing door handle