Volkswagen Golf Service & Repair Manual: Cylinder block (pulley end)
- Assembly overview - poly V-belt drive, vehicles without air conditioner compressor
- Assembly overview - poly V-belt drive, vehicles with air conditioner compressor
- Assembly overview - sealing flange, belt pulley end
- Removing and installing poly V-belt, vehicles without air conditioner compressor
- Removing and installing poly V-belt, vehicles with air conditioner compressor
- Removing and installing tensioner for poly V-belt, vehicles without air conditioner compressor
- Removing and installing tensioner for poly V-belt, vehicles with air conditioner compressor
- Removing and installing vibration damper
- Removing and installing engine support
- Renewing crankshaft oil seal - belt pulley end
- Removing and installing sealing flange on pulley end
Assembly overview - poly V-belt drive, vehicles without air conditioner
compressor
1 -
Bolt
Renew
150 Nm +180°
Use counterhold -T10475- to loosen and tighten.
Risk of damage to engine caus ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Warning and indicator lamps
→ Engine oil specification
→ Checking the engine oil level and refilling engine oil
→ Engine oil consumption
→ Changing engine oil
Additiona ...
Restrictor
The restrictor creates a restriction. This restriction
limits the flow, separating the high-pressure and low-pressure
sides in the refrigerant circuit. Upstream of the restrictor,
the refrigerant is warm due to the high pressure. Downstream of
the restri ...
Removing and installing Valeo heat exchanger, LHD vehicles
Special tools and workshop equipment
required
Drip tray for workshop hoist -VAS 6208-
Hose clamps up to 25 mm -3094-
...
