Volkswagen Golf Service & Repair Manual: Removing and installing tensioner for poly V-belt, vehicles with air
conditioner compressor
| – |
Remove poly V-belt from tensioner
→ Chapter „Removing and installing poly V-belt, vehicles with
air conditioner compressor“. |
|
|
|
| – |
Remove bolts -arrows- and
detach poly V-belt tensioner -1-. |
| Installation is carried out in the reverse order; note the
following: |
| – |
Install poly V-belt
→ Chapter. |
| → Chapter „Assembly overview - poly V-belt drive, vehicles with
air conditioner compressor“ |
|
|
|
Removing
–
Remove poly V-belt from tensioner
→ Chapter „Removing and installing poly V-belt, vehicles without
air co ...
Special tools and workshop equipment
required
Counterhold -T10475-
Removing
...
Other materials:
Assembly overview - rear centre three-point seat belt
1 -
Belt buckle
With rear belt switch, front passenger side -E259-
Removing and installing
→ Chapter
Always renew after belt tensioner has deployed with seat belt fastened
Must rest flat against contact surface when tightening nut
2&n ...
Notes on releasing and dismantling contact housings
Note
Observe the general notes on repairs to the vehicle
electrical system
→ Chapter.
To release, always use the correct release tools. Under no
circumstances should the contacts be pulled out of the ...
Introduction
This chapter contains information on the following subjects:
→ Preparing for a journey and driving safely
→ Driving abroad
→ Driving through water on roads
Depending on where the vehicle is used, it could be a good idea to have an engine
and transmiss ...
© 2016-2025 Copyright www.vwgolf.org
Removing and installing tensioner for poly V-belt, vehicles without air
conditioner compressor
Removing and installing vibration damper