Volkswagen Golf Service & Repair Manual: Control units
- Overview of fitting locations – control units, front of LHD vehicles
- Overview of fitting locations – control units, front of RHD vehicles
- Overview of fitting locations – control units, rear
- Assembly overview - control units, LHD vehicles
- Assembly overview - control units, RHD vehicles
- Assembly overview - data bus diagnostic interface
- Removing and installing onboard supply control unit -J519-, LHD vehicles
- Removing and installing onboard supply control unit -J519-, RHD vehicles
- Removing and installing data bus diagnostic interface -J533-
- Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles
- Removing and installing bracket for onboard supply control unit -J519-, RHD vehicles
- Renewing bracket for onboard supply control unit -J519-, LHD vehicles
- Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles
- Removing and installing engine sound generator control unit -J943-, vehicles with active sound, Golf GTD
Removing and installing fuse holder, battery
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
...
Overview of fitting locations – control units, front of LHD vehicles
1 -
Data bus diagnostic interface -J533-
Assembly overview
→ Chapter
2 -
Bracket
Assembly overvie ...
Other materials:
Wear in middle of tyre
This wear pattern is found on the driven wheels of
high-performance vehicles that are frequently driven long
distances at high speeds.
At high speeds, centrifugal forces cause the tyre diameter
to increase more in the middle of the tread ...
Removing and installing anti-roll bar
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
Loosen wheel bolts.
–
...
Removing and installing camshaft adjuster
Special tools for removing and installing the camshaft
adjuster of exhaust camshaft
Special tools and workshop equipment
required
Support bracket -10 - 222 A-
...
