Volkswagen Golf Service & Repair Manual: Renewing bracket for onboard supply control unit -J519-, LHD vehicles

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Renewing bracket for onboard supply control unit -J519-, LHD vehicles

Removing

–	Remove bracket for onboard supply control unit -J519- → Chapter.

–	Remove onboard supply control unit -J519- → Chapter.

–	Remove parking aid control unit -J446-/park assist steering control unit -J791- → Chapter.

–	Remove front parking aid warning buzzer -H22- → Chapter.

Installing

Installation is carried out in the reverse sequence.

Renewing bracket for onboard supply control unit -J519-, RHD vehicles

Removing

–	Remove bracket for onboard supply control unit -J519- → Chapter.

–	Remove onboard supply control unit -J519- → Chapter.

–	Remove front parking aid warning buzzer -H22- → Chapter.

Installing

Installation is carried out in the reverse sequence.

Removing and installing bracket for onboard supply control unit -J519-, RHD vehicles

Removing – With ignition switched off, disconnect earth cable from battery → Chapter. – ...

Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles

Special tools and workshop equipment required Feeler gauge Removing – If fitted, re ...

Other materials:

Removing and installing entry light in exterior mirror
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Note Removal and installation are described for the left side. Removal and insta ...

Assembly overview - impact bar
1 - Impact bar 2 - Guide bracket Left and right 3 - Hexagon nut Qty. 2 on each side 2.0 Nm 4 - Bolt Qty. 2 on each side 8 Nm 5 - Bolt ...

Dimensions – “e-Golf” lettering on rear lid
Note When fitting the lettering, observe the fitting notes → Anchor. 1 - Lettering Model designation 2 - Height dimension 75.5 ± 1 mm, from lower edge of lettering to tail light 3& ...