Volkswagen Golf Service & Repair Manual: Steering column switch module
- Assembly overview - steering column switch module, with mechanical ignition lock
- Assembly overview - steering column switch module, with electronic ignition lock
- Removing and installing lock cylinder
- Removing and installing ignition key withdrawal lock solenoid -N376-
- Removing and installing ignition/starter switch
- Removing and installing steering column switch module, Kostal
- Removing and installing steering column switch module, Valeo
- Removing and installing steering column electronics control unit -J527-, Kostal
- Removing and installing steering column electronics control unit -J527-, Valeo
- Removing and installing turn signal switch -E2-, Kostal
- Removing and installing turn signal switch -E2-, Valeo
- Removing and installing cruise control system switch -E45
- Removing and installing intermittent wiper switch -E22-
- Removing and installing immobiliser reader coil -D2-, vehicles with keyless access locking and starting system
- Removing and installing steering lock housing
Removing and installing rear bumper aerial for entry and start system -R136-
Removing
–
Remove bumper cover
→ General body repairs, exterior; Rep. gr.63.
...
Assembly overview - steering column switch module, with mechanical ignition
lock
1 -
Ignition key
2 -
Lock cylinder
Removing and installing
→ Chapter
3 -
Immobiliser re ...
Other materials:
Removing and installing seat trim on sill side, seat of type "ergo Aktiv"
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Overview of fitting locations - auxiliary heater
1 -
Auxiliary heater
With auxiliary heater control unit -J364-.
Removing
→ Chapter
2 -
Nut
20 Nm
3 -
Electrical connectors
4 -&nbs ...
Removing and installing coolant pipes
Special tools and workshop equipment
required
Hose clamps up to 25 mm -3094-
Hose clip pliers -VAS 6362-
...
