Volkswagen Golf Service & Repair Manual: Removing and installing steering column switch module, Kostal

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Steering column switch module / Removing and installing steering column switch module, Kostal

Removing

–	Move steering wheel to rearmost and lowest position. Use the entire range of adjustment of the steering column for this purpose.

–	Remove steering wheel → Running gear, axles, steering; Rep. gr.48.

–	Remove lower steering column trim → General body repairs, interior; Rep. gr.68.

WARNING

Risk of damage to the electronic components due to electrostatic discharge.

Before disconnecting the electrical connector, the mechanics must electrostatically discharge themselves by briefly grasping hold of door striker plate or similar.

Removing and installing steering column switch module, Kostal

–	Pull out connector lock in direction of arrow -A- and press it down.

–	Disconnect electrical connector -1-.

–	Pull out connector lock in direction of arrow -B- and press it down.

–	Disconnect electrical connector -2-.

–	Press connector lock in direction of arrow -C- and disconnect electrical connector -3-.

–	Unscrew bolt -2- on underside.

–	Pull off steering column switch module -1-.

Installing

Install in the reverse order of removal, observing the following:

Removing and installing steering column switch module, Kostal

–	Before pushing on steering column switch module, ensure the following for steering column electronics control unit -J527--3-:

The “arrows”-1- must align.

Coil connector -2- must be visible through window between “arrows”-4-.

Specified torques

→ Chapter „Assembly overview - steering column switch module“

Removing and installing steering column switch module, Kostal

Removing and installing ignition/starter switch

Removing – Remove lower steering column trim → General body repairs, interior; Rep. gr.68. & ...

Removing and installing steering column switch module, Valeo

Removing – Move steering wheel to rearmost and lowest position. Use the entire range of adjustment of the steering column for this ...

Other materials:

Assembly overview - drive unit of air conditioner compressor, Golf and Golf Estate
Note The illustration shows a different version. 1 - Poly V-belt Removing and installing → Rep. gr.13. Mark the direction of rotation and ensure t ...

Overview of fitting locations – central locking
1 - Coupling station Fitting location: right A-pillar To separate connections, release bellows at pillar 2 - Onboard supply control unit -J519- Location: Under dash panel on driver side Removing → Electrical syste ...

Description of the central locking system
First read and observe the introductory information and safety warnings The central locking system enables you to lock and unlock all the doors, the tailgate and tank flap from one central point: From outside the vehicle with the vehicle key . From outside the vehicle with Keyl ...