VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - steering column switch module, with mechanical ignition lock

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Steering column switch module / Assembly overview - steering column switch module, with mechanical ignition lock

Assembly overview - steering column switch module, with mechanical ignition lock

1 -  Ignition key
2 -  Lock cylinder
Removing and installing → Chapter
3 -  Immobiliser reader coil -D2-
Removing and installing → Chapter
4 -  Mounting
With turn signal switch -E2-, intermittent wiper switch -E22-
Vehicles with cruise control system: with cruise control system switch -E45-.
Removing and installing → Chapter
5 -  Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
Removing and installing → Chapter
  Caution
Risk of damage to the return ring.
When removed, the return ring with slip ring must not be turned.
6 -  Bolt
Qty. 3
Specified torque: 1.1 Nm
7 -  Ignition/starter switch -D-
Removing and installing → Chapter
8 -  Steering lock housing
Removing and installing → Chapter
9 -  Bolt
Specified torque: 1.1 Nm
10 -  Ignition key withdrawal lock solenoid -N376-
Versions with dual clutch gearbox
Removing and installing → Chapter
11 -  Steering column
12 -  Bolt
Qty. 2
For steering lock housing (shear bolt)
Steering column switch module
...

Assembly overview - steering column switch module, with electronic ignition lock
1 -  Starter button -E378- Overview of fitting locations → Chapter 2 -  Steering column electronics control unit -J5 ...

Other materials:

Removing and installing control unit and hydraulic unit, LHD vehicles, four-wheel drive, diesel engine
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Torque wrench -V.A.G 1410- Brake pedal depressor -V.A.G 1869/2-         Sealing plugs, assemb ...

Overview of fitting locations - storage compartments/covers
1 -  Dash panel Assembly overview → Chapter 2 -  Glove compartment Assembly overview → Chapter 3 -  Centre console Assembly overview → Chapter 4  ...

Checking radial and lateral runout on wheels and tyres with tyre gauge
Checking lateral run-out –  Preload tyre gauge approx. 2 mm.     –  Fit tyre gauge to side wall of tyre. –  Turn wheel slowly. ...

© 2016-2026 Copyright www.vwgolf.org