Volkswagen Golf Service & Repair Manual: Assembly mountings
- Assembly overview - assembly mountings
- Supporting engine in installation position
- Removing and installing engine mountings
- Removing and installing gearbox mounting
- Removing and installing pendulum support
- Checking adjustment of assembly mountings (engine and gearbox mountings)
- Adjusting assembly mountings
Installing engine
Procedure
Engine/gearbox assembly secured to engine support T10497.
Note
Renew bolts that are tightened w ...
Assembly overview - assembly mountings
1 -
Bolt
Renew
Tightening sequence → Fig.
2 -
Engine support
Specified torque and ti ...
Other materials:
Wheel alignment procedure
Always adhere to the following procedure!
Note
The vehicle must always be in unladen condition when
measuring wheel alignment
→ Chapter.
–
T ...
Removing and installing front body acceleration senders -G341-/-G342-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Pull seal off entire length of plenum chamber cover.
...
Adjusting toe on rear axle, multi-link suspension
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
–
Loosen nut -1-.
–&nb ...
