Volkswagen Golf Service & Repair Manual: Checking adjustment of assembly mountings (engine and gearbox mountings)

Procedure

The following specifications must be obtained:

There must be a distance of -a- = 10 mm between engine support -2- and engine mounting -1-.

Side surface of engine support casting -2- must be located parallel to support arm of engine mounting -1-.

Distance -b- = distance -b-.

Note

Distance -a- = 10 mm can be checked with a metal rod of suitable size, or similar.

–	If the dimension is too small or too high, adjust assembly mountings → Chapter.

Checking adjustment of assembly mountings (engine and gearbox mountings)

Remove noise insulation → General body repairs, exterior; Rep. gr.66. – ...

Procedure – Remove battery tray → Electrical system; Rep. gr.27. ...

Assembly overview - wheel bearing assembly, torsion beam axle
1 - Dust cap Renew after removing Pressing off and driving in → Chapter A proper seal can be achieved only by installing a new dust cap. 2 - Bolt Renew after remov ...

Removing and installing thermostat for small cooling circuit
Removing – Remove coolant pump → Chapter. – Remove bolts in the sequence -F … A-. – Detach coolant pump from ...

Removing and installing windscreen washer fluid level sender, »R«
Special tools and workshop equipment required Drip tray Note Dependent on the equipment level, the windscreen washer fluid level sender -G33- may either be renewed individually or together with ...