Volkswagen Golf Service & Repair Manual: Alternator
- Assembly overview - alternator without sliding bushes
- Assembly overview - alternator with sliding bushes
- Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l TSI engine and 1.4 l TSI natural gas engine
- Removing and installing alternator, vehicles with 2.0 l TSI engine
- Removing and installing alternator, vehicles with TDI engine
- Removing and installing alternator, GTD
- Removing and installing poly V-belt pulley without freewheel
- Removing and installing poly V-belt pulley with freewheel, manufacturer: Bosch
- Removing and installing poly V-belt pulley with freewheel, manufacturer: Valeo
- Removing and installing decoupler pulley with freewheel
- Removing and installing voltage regulator, manufacturer: Bosch
- Removing and installing voltage regulator, manufacturer: Valeo
Removing and installing earth wire with battery monitor control unit -J367-,
vehicles with high-voltage system
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
Assembly overview - alternator without sliding bushes
1 -
Bolt
Qty. 4
Specified torque: 23 Nm
2 -
Alternator -C-
Removing and installing
→& ...
Other materials:
Leak detection in refrigerant circuit using compressed air or nitrogen
Note
A leak in the refrigerant circuit can be detected, for
example, by pressurising the circuit to a maximum of 15 bar
using cleaned and dried compressed air or nitrogen
→ Chapter. If the leak is large, the leakage point
...
Removing and installing head restraint
Removing
–
Press release button -3- for
height adjustment on head restraint guide
-4- in -direction of arrow-.
–
At the same time pull head restraint
-1- out of rear seat backrest -2-
...
Removing and installing earth wire with battery monitor control unit -J367-,
vehicles with high-voltage system
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Switch off ignition.
–
...
