Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
Assembly overview - brake pedal, RHD vehicles
The brake pedal travel must not be restricted by additional floor
coverings.
Note
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry.
1 -
Bolt
20 Nm
2 -
Mounting b ...
Refrigerant circuit components
Caution
Non-authorised tools or materials (e.g. leak
inhibitor additive) may cause damage or adversely
influence the system.
Only tools and materials approved by the
manufac ...