Volkswagen Golf Service & Repair Manual: Control unit and hydraulic unit
- Assembly overview - control unit and hydraulic unit, LHD vehicles
- Assembly overview - control unit and hydraulic unit, RHD vehicles
- Removing and installing control unit and hydraulic unit, LHD
- Removing and installing control unit and hydraulic unit, RHD vehicles
- Connecting brake lines to hydraulic unit, LHD vehicles
- Connecting brake lines to hydraulic unit, RHD vehicles
- Separating control unit from hydraulic unit
- Fitting control unit to hydraulic unit
Overview of fitting locations
Overview of fitting locations - ABS/ESP
1 -
ABS control unit -J104-
Installation location: on hydraulic unit, on passenger side of
engine c ...
Assembly overview - control unit and hydraulic unit, LHD vehicles
1 -
Brake line
From primary piston circuit of brake master cylinder to hydraulic
unit.
Identification: Ш 6 mm and flare nut with ...
Other materials:
Assembly overview - poly V-belt drive, vehicles with air conditioner
compressor
1 -
Poly V-belt
Check for wear
Before removing, mark direction of rotation with chalk or
felt-tipped pen.
Do not kink
The length of the poly V-belt must be determined according to the
→ E ...
Checking seat belt restraint function for holding additional child seats
(not for driver seat belt) - country-specific
For the functional check, all surrounding components for the
seat belt including the side panel trim must be installed.
Activating the restraint function
Pull out seat belt webbing completely to stop.
...
Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
front-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Rear left speed sensor -G46--1-:
...
