Removing and installing brake caliper PC57
Assembly overview - rear brake caliperWiring open circuit with one repair position
Repair position with single crimp connector
–
Place the wire to be repaired to one side (about 20 cm
either side of the repair position).
–
If necessary, unbind the wir ...
Changing engine oil
First read and observe the introductory information
and safety warnings The engine oil must be changed regularly in accordance
with the data given in the service schedule.
The engine oil and filter change should always be carried out by a qualified
workshop due to the special tools and kno ...
Removing and installing defroster flap control motor -V107- with
potentiometer -G135-, RHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...