Volkswagen Golf Service & Repair Manual: Valve gear
- Assembly overview - valves
- Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
- Removing and installing camshaft adjuster
- Measuring axial play of camshaft
- Removing and installing inlet camshaft oil seal, pulley end, engine codes CPTA, CHPA, CZEA, CZDA
- Removing and installing exhaust camshaft oil seal, pulley end, engine codes CPTA, CHPA, CZEA, CZDA
- Removing and installing exhaust camshaft oil seal, gearbox end, engine codes CHPA, CMBA, CPVA, CXSA, CZDA, CZCA, CPVB
- Removing and installing valve stem seals (cylinder head installed)
- Removing and installing valve stem seals (cylinder head removed)
Checking compression
Special tools and workshop equipment
required
Spark plug socket and extension -3122 B-
...
Assembly overview - valves
1 -
Inlet valve
Do not rework. Only lapping in is permitted.
Valve dimensions
→ Chapter
Checking valve guid ...
Other materials:
Refrigerant circuit components
Caution
Non-authorised tools or materials (e.g. leak
inhibitor additive) may cause damage or adversely
influence the system.
Only tools and materials approved by the
manufac ...
Removing and installing oil pressure regulating valve -N428-
Removing
Note
Fit all heat insulation sleeves in the original position
when installing.
–
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66.
...
Checking metering pump -V54- with end sealing valve
–
If you are uncertain as to whether the metering pump -V54--C-
has an end sealing valve or not, connect e.g. hand vacuum pump
-VAS 6213- to connection -A-.
–
Use hand-operated vacuum pump to a generate a vacuum of ...
