Volkswagen Golf Service & Repair Manual: Suspension strut, shock absorber, spring
- Assembly overview - suspension strut, shock absorber, spring, torsion beam axle
- Assembly overview - suspension strut, shock absorber, spring, multi-link suspension
- Removing and installing shock absorber, torsion beam axle
- Removing and installing shock absorber, multi-link suspension, left shock absorber
- Removing and installing shock absorber, multi-link suspension, right shock absorber
- Repairing shock absorber
- Removing and installing spring, torsion beam axle
- Removing and installing spring, multi-link suspension, left spring for front-wheel drive, left and right spring for four-wheel drive
- Removing and installing spring, multi-link suspension, right spring for front-wheel drive
Removing and installing track rod
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Assembly overview - suspension strut, shock absorber, spring, torsion beam
axle
1 -
Bolt
Renew after removing
50 Nm +45°
2 -
Shock absorber
Removing and installing ...
Other materials:
Checking holding pressure, engine code CWVA
Special tools and workshop equipment required
Pressure tester -VAS 6550-
Removal wedge -3409-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...
Refrigerant circuit seals
Renew seals.
Moisten seals with refrigerant oil before installing.
Ensure proper seating of seals on the pipe or in the groove.
Work in a completely clean environment (the smallest
particles ...
Renewing Lambda probe
Note
Do not repair Lambda probe wires, since this can result in
malfunctions.
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified. ...
