Volkswagen Golf Service & Repair Manual: Rear suspension, drive shaft

Checking inner constant velocity joint

Removing The joint is to be dismantled when following work is done: Replacement of grease if very contaminated ...

Rear axle

Overview - rear axle, torsion beam axle I -  → Chapter „Axle beam“ II -  → Chapter „Suspension strut, shock absorber, s ...

Other materials:

Removing and installing interface for entry and start authorisation system -J965-
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. The removal and insta ...

Introduction
This chapter contains information on the following subjects:  → Display and indicator lamps   → Function    → Switch off the lane departure warning system in the following situations   Additional information and warnings: Exterior views   Volkswagen in ...

Removing and installing spring, multi-link suspension, right spring for front-wheel drive
Special tools and workshop equipment required     Spring compressor -V.A.G 1752/1-   Spring retainer -V.A.G 1752/3A- ...