Volkswagen Golf Service & Repair Manual: Bonnet
- Assembly overview - bonnet
- Assembly overview - Bowden cable
- Removing and installing bonnet
- Adjusting bonnet
- Removing and installing bonnet lock, LHD vehicle
- Removing and installing bonnet lock, RHD vehicle
- Removing and installing bonnet release lever
- Removing and installing striker pin
- Removing and installing hinges
- Removing and installing insulation
- Removing and installing gas strut
- Releasing gas from gas strut
- Removing and installing Bowden cable
Assembly overview - bonnet
1 -
Bonnet
Removing and installing
→ Chapter
Adjusting
→ Chapter
2 -
Adjustment buffer
Qty. 2
...
Other materials:
Assembly overview - speed sensor on rear axle, all-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
Removing and installing fresh air/recirculated air, air flow flap control
motor -V425-, LHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
Removing and installing auxiliary air heater element -Z35- with auxiliary
air heater control unit -J604-, LHD vehicles
Removing
–
Remove driver side knee airbag
→ General body repairs, interior; Rep. gr.69.
–
Remove left centre console trim in footwell
→ General body repairs, interior ...
