Volkswagen Golf Service & Repair Manual: Removing and installing insulation
|
| – | Lever retaining clips -2- out of bonnet -3- using removal lever -80-200-. |
| – | Pull insulation -1- out of elongated holes -arrows-. |
|
| l | When installing insulation -1-, ensure that retaining clips -2- are fitted with wide side outwards. |
| – | Slide insulation -1- with fitting lugs -arrows- in longitudinal holes. |
| – | Insert all retaining clips -2- into bonnet -3-. |
Removing and installing hinges
Special tools and workshop equipment
required
Note
Removal and installation are described for ...
Removing and installing gas strut
Removing
–
Open and support bonnet.
WARNING
Proceed with care if gas strut is reused. Spring clip must
not be le ...
Other materials:
Overview of fitting locations - front control motors, air conditioning system
with electric/manual controls, RHD vehicles
1 -
Temperature flap control motor -V68-
Checking: with vehicle diagnostic tester
Removing and installing
→ Chapter.
Renewing: initiate basic setting using vehicle diagnostic tester.
2 -&nb ...
Adjusting the driving mode to suit your requirements
First read and observe the introductory information
and safety warnings The systems that can be adjusted to your individual requirements
depend on the vehicle equipment level.
Switch on the ignition.
If necessary, switch on the infotainment system.
Press the Driving Mode Selec ...
Aqua-Premium - application instructions for water-based products
Issued 06.2013
When using water-based products always devote scrupulous
care to the substrate preparations before pretreating with the
materials specifically recommended for use with water-based
products.
Substrate ...
