1 - | Bonnet |
2 - | Adjustment buffer |
3 - | Insulation |
4 - | Seal in centre |
5 - | Striker pin |
6 - | Bolt |
7 - | Seal on side |
8 - | Hinge |
9 - | Hexagon nut |
10 - | Bolt |
11 - | Protective film |
12 - | Bonnet lock |
13 - | Bolt |
Removing and installing headlight range control unit -J431-/control unit for
cornering light and headlight range control -J745-, RHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
â ...
Moving wipers to service position
Caution
Risk of damaging the bonnet when moving wipers back
into the park position.
Do not manoeuvre the vehicle with wiper arms folded
out.
...
Checking pistons and cylinder bores
Checking piston
–
Using a micrometre, measure approx. 10 mm from the lower
edge, perpendicular to the piston pin axis.
Maximum deviation from nominal dimension: 0.04 mm
...