Volkswagen Golf Service & Repair Manual: Safety information
- Safety measures when working on vehicles with a Start/Stop system
- Safety measures when working with pyrotechnic components
- Storage, transportation and disposal of airbag, belt tensioner and battery isolator units (pyrotechnic components)
- Additional safety regulations for side airbag
- Additional safety instructions for curtain airbag
- Safety regulations for crash sensors (pressure sensors) for front side airbags
- Renewing pyrotechnic, electrical and mechanical components of the restraint system after an accident
- Checking airbag securing parts after an accident
- Checking seat belts
- Checking belt webbing
- Checking inertia reel (locking mechanism)
- Checking operation of belt buckle
- Checking belt guide fittings and latch plates
- Checking securing parts and anchorage points after an accident
- Checking seat belt restraint function for holding additional child seats (not for driver seat belt) - country-specific
- Checking child seat anchors after an accident
- Safety instructions for automatically dimmable interior mirror
Technical data
...
Safety measures when working on vehicles with a Start/Stop system
Observe the following when working on vehicles with a
Start/Stop system:
WARNING
Risk of injury due t ...
Other materials:
Assembly overview - anti-roll bar, multi-link suspension, four-wheel drive
1 -
Lower transverse link
2 -
Nut
Renew after removing
20 Nm +180°
3 -
Coupling rod
Removing and installing
→ Chapter
4 -
...
Round connector systems
Note
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the prescribed tool
→ Chapter.
...
Removing and installing amplitude modulation (AM) frequency filter -R177-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Switch off ignition and all electrical consumers, and remov ...
