Volkswagen Golf Service & Repair Manual: Checking securing parts and anchorage points after an accident
| Latch plate deformed (stretched) |
| |
Height adjustment does not function. |
| |
Anchorage points (seat, pillars, underbody) distorted or
thread damaged |
| |
If damage is determined on these parts, renew seat belt
complete with belt buckle. |
| |
If parts of the belt system are removed because of an
accident, the belt system securing bolts must be renewed. |
 Note
| In the case of damage resulting not from an accident but,
for example, from wear, only the part which is actually damaged
need be renewed. |
|
Plastic-coated fittings show fine, parallel scoring after
stress on belt system (when belt was fastened during accident).
(On the other hand, wear caused by frequent ...
For the functional check, all surrounding components for the
seat belt including the side panel trim must be installed.
Activating the restraint func ...
Other materials:
Water content
Only very small amounts of water are soluble in liquid
refrigerant. On the other hand, refrigerant vapour and water
vapour mix in any proportion.
Any water present in the refrigerant circuit will be carried
along as droplets. The dessica ...
Lowering rear axle, multi-link suspension, front-wheel drive, except for
e-Golf
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
Lower subframe ...
Assembly overview - steering rack, left-hand drive
Caution
The following work must not be performed while the universal
joint is separated from the steering rack:
Connect battery.
Switch on ignition.
Turn steering rack.
...
© 2016-2026 Copyright www.vwgolf.org
Checking belt guide fittings and latch plates
Checking seat belt restraint function for holding additional child seats
(not for driver seat belt) - country-specific