This chapter contains information on the following subjects:
→ Sockets in the vehicle
Electrical equipment can be connected to the sockets in the vehicle.
The devices connected must be in good condition and fault-free.
Additional information and warnings:

WARNING

NOTICE
Do not leave the engine running when the vehicle is stationary.
Using electrical appliances with the engine switched off and the ignition switched on will drain the battery.
Unshielded devices can cause interference with radio reception and vehicle electronics.
Interference of AM radio reception could occur if electric devices are used in the vicinity of the rear window aerial.
Sockets in the vehicleAssembly overview - steering column switch module, with electronic ignition
lock
1 -
Starter button -E378-
Overview of fitting locations
→ Chapter
2 -
Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
...
COC document (EEC Certificate of Conformity)
Manufactures of motorized vehicles must apply for an EU
operating permit for all class M1 passenger carrying vehicles.
A certificate is produced on the basis of this operating
permit - the COC (Certificate of Conformity).
...
Removing and installing rear parking aid senders
Removing
Outer rear senders:
Note
The outer rear parking aid senders can be removed and
installed without the need to remove the rear bumper.
–&nb ...