Volkswagen Golf Service & Repair Manual: Checking seat belt restraint function for holding additional child seats
(not for driver seat belt) - country-specific
| For the functional check, all surrounding components for the
seat belt including the side panel trim must be installed. |
| Activating the restraint function |
| |
Pull out seat belt webbing completely to stop. |
| |
The belt must retract with an audible noise. |
| |
If the belt retraction is stopped, it should not be possible
to pull the belt out again until the function is deactivated. |
-
| |
Allow the belt to retract as far as the last 100 mm
(approx.). |
-
| |
When 100 mm of the seat belt webbing are still pulled
out, the restraint function must switch off at the latest.
The belt then works normally again. |
| If the seat belt restraint function for holding additional
child seats does not work properly, the seat belt must be
renewed. |
|
|
|
Latch plate deformed (stretched)
Height adjustment does not function.
Anchorage points (seat, pillars, und ...
Points to check
Child seat anchors must be checked for damage and
deformation after an accident.
Child seat anchors welded to the body ...
Other materials:
Checking colour indicator, “3-colour”
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
General information about colour indicator:
Applies fo ...
Removing and installing brake caliper
Special tools and workshop equipment required
Vehicle diagnosis, testing and information system -VAS 5051-
Tool set for brake bleeding -VAS 6564-
Insert tool with ratchet -VAS 6784-
Bit attachment (7 mm) -T10503-
...
Renewal of aerial wiring
A new approach to repair work on aerial wires has been
developed
→ Chapter.
Now connecting wires in different lengths and various
adapter cables are available as replacement parts instead of a
complete aerial wire.
...
© 2016-2026 Copyright www.vwgolf.org
Checking securing parts and anchorage points after an accident
Checking child seat anchors after an accident