Volkswagen Golf Service & Repair Manual: Checking inertia reel (locking mechanism)

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Technical data / Safety information / Checking inertia reel (locking mechanism)

The inertia reel has two locking functions.

The first locking function is triggered by the belt being jerked out of the reel (belt extension acceleration).

Test 1

–	Pull belt out of inertia reel with firm jerk.

Will not lock - renew seat belt complete with buckle.

If difficulties are experienced when belt is extended or retracted, first check whether position of inertia reel has been altered.

The second locking function is triggered by a change in vehicle speed (vehicle-dependent locking function).

Test 2

WARNING

For safety reasons, the road test should be carried out on a traffic-free stretch to ensure that other road users are not endangered.

–	Put on seat belt.

–	Accelerate vehicle to 20 km/h and then carry out emergency braking with foot brake.

If seat belt is not locked by locking mechanism during braking procedure, renew seat belt complete with buckle.

Visually inspecting belt buckle

Inspect belt buckle for cracks and chips.

If damage is determined, renew seat belt complete with belt buckle.

Checking belt webbing

Procedure – Pull belt completely out of inertia reel or lap belt adjustment plate. – Check belt we ...

Checking operation of belt buckle

Checking belt buckle – Push latch plate into belt buckle until it engages audibly. Check whether locking mechanism is properly engaged ...

Other materials:

Adjusting striker pin
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Note Threaded plate -1- of striker pin is secured in pillar using a method which differs f ...

Assembly overview - suspension strut, shock absorber, spring, multi-link suspension
1 - Bolt Renew after removing 50 Nm +45° 2 - Shock absorber Removing and installing → Chapter Note correct installation position of cable tie fastener. ...

Checking radial and lateral runout of wheels and tyres, tolerances
Radial and lateral run-out occur when the wheel and tyre do not run absolutely true. For technical reasons, 100% true running is not possible. Therefore, the manufacturers of these components allow a precisely determined ...