Volkswagen Golf Service & Repair Manual: Rear lid
- Assembly overview - rear lid
- Removing and installing rear lid
- Adjusting rear lid
- Removing and installing bonnet lock
- Removing and installing hinges
- Removing and installing striker pin
- Removing and installing rear lid seal
- Removing and installing gas strut
- Releasing gas from gas strut
Removing and installing Bowden cable
Removing
–
Open bonnet.
–
Remove release lever
→ Chapter.
â ...
Assembly overview - rear lid
1 -
Rear lid
Removing and installing
→ Chapter
Adjusting
→ Chapter
2 -
Bonnet lock
Removing and insta ...
Other materials:
Removing and installing plenum chamber bulkhead
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Removing plenum chamber cover
→ Chapter.
...
Operating the speed limiter
Fig. 164 Left-hand side of the steering
column: switch and buttons for operating the speed limiter
Fig. 165 Left-hand side of the multifunction
steering wheel: buttons for operating the speed limiter
First read and observe the introductory information
and safety warnings 
...
Assembly overview - drive shaft, triple roller joint AAR3300i
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
