Volkswagen Golf Service & Repair Manual: Oil filter, oil pressure switch

Removing and installing oil separator

Special tools and workshop equipment required Flat scraper Commercially available studs, M6x20 mm, qty.  ...

Assembly overview - oil filter/oil pressure switch

1 -  Oil filter Remove and install with oil filter tool -3417-. Before installing, lightly coat seal with clean engine oil. ...

Other materials:

Removing and installing heat exchanger for high-voltage battery
Special tools and workshop equipment required Hose clamps, up to 25 mm -3094- Engine bung set -VAS 6122- Pliers for spring-type clips -VAS 5024A- Cooling sy ...

Assembly overview - speed sensor on rear axle
1 -  ABS speed sensor Before inserting sensor, clean inner surface of fitting hole and coat it with high-temperature paste -G 052 112 A3-. Removing and installing → Chapter 2 -  Bolt ...

Removing and installing wheel bearing unit, torsion beam axle
Special tools and workshop equipment required Fitting sleeve -3241/4- Hub grease cap puller -VW 637/2- Torque wrench -V.A.G 1332- Tool insert -T10162 A- Torque wrench -V.A.G 1410-   ...