Volkswagen Golf Owners Manual: Cleaning seat belts
First read and observe the introductory information
and safety warnings
Large particles of dirt on the automatic belt prevent
it from rolling back properly and thus from working effectively.
The seat belts must never be removed for cleaning purposes.
- Remove dirt with a soft brush .
- Carefully pull the dirty seat belt right out and leave it out.
- Clean the seat belt with a mild soap solution.
- Allow the seat belt fabric to dry completely.
- Do not allow the seat belt to roll up until it has dried completely.

WARNING
Check the condition of all seat belts regularly. If the belt webbing or any other
part of the seat belt becomes damaged have it removed and replaced immediately by
a qualified workshop. Damaged seat belts are very dangerous and can cause severe
or fatal injuries.
- Never use chemical cleaning agents on the seat belts or their components.
Furthermore the seat belts may not come into contact with corrosive fluids,
solvents or sharp objects. These could considerably weaken the webbing.
- After cleaning, allow seat belts to dry completely before rolling them up.
Otherwise the automatic belt retractors could become damaged and thus impair
their function.
- Avoid allowing foreign bodies or liquids to enter the slot for the seat
belt buckle. This could prevent the belt buckle and seat belt from working properly.
- Never try to repair, modify or remove the seat belts yourself.
- Damaged seat belts must be replaced immediately with new seat belts approved
by Volkswagen for your vehicle type. Seat belts subjected to stress and stretched
during an accident must be replaced by a qualified workshop. Renewal may be
necessary even if there is no apparent damage. The belt anchorage should also
be checked.
First read and observe the introductory information
and safety warnings
Moisten a clean, lint-free cloth with water and clean the parts.
Treat plastic parts (inside and outside the vehicl ...
Other materials:
Removing and installing D-pillar trim
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Removing and installing door lock
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Socket -3410-
Note
Rem ...
Contents of the breakdown set
Fig. 227 The breakdown set
First read and observe the introductory information
and safety warningsThe breakdown set may be located in various places in
the vehicle, e.g. in the side stowage area of the luggage compartment or under the
floor covering in the variable luggage compartment. It in ...
© 2016-2025 Copyright www.vwgolf.org
