Volkswagen Golf Service & Repair Manual: Removing and installing oil pressure regulating valve -N428-

Removing

Note

Fit all heat insulation sleeves in the original position when installing.

–	Remove noise insulation → General body repairs, exterior; Rep. gr.66.

–	Detach heat insulation sleeves.

–	Disconnect electrical connector -1-.

Note

Place a cloth underneath to catch escaping engine oil.

–	Unscrew bolt -2- and pull off valve for oil pressure control -N428-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew O-ring.

–	Install noise insulation → General body repairs, exterior; Rep. gr.66.

Specified torques

→ Chapter „Assembly overview - oil filter/oil pressure switch“

Removing and installing oil pressure regulating valve -N428-

Special tools and workshop equipment required Jointed wrench 24 mm -T40175- Remo ...

Special tools and workshop equipment required Oil pressure tester -V.A.G 1342- P ...

Front brakes
Item PR No. 1ZF 1 Brake caliper FS III (15”) 2 Brake pad, thickness mm 12 Brake pad, wear limit without backplate mm 2 3 Brak ...

Layout - infotainment system, Composition Touch and Composition Colour version
Display unit for control device of front display and information control panel -J685- Optional CD drive Features of infotainment system Composition Touch 5-inch monochr ...

Removing and installing belt height adjuster, 4-door model and estate
Removing – Press belt height adjuster button and move slider of belt height adjuster to lowest position. – Detach upper B-pillar trim → Chapter. – ...