Volkswagen Golf Service & Repair Manual: Noise insulation
- Assembly overview – underbody covers, petrol/diesel
- Assembly overview – underbody covers, e-Golf
- Assembly overview - underbody covers, hybrid vehicles
- Removing and installing underbody covers – petrol/diesel
- Removing and installing front underbody cover – e-Golf
- Removing and installing centre underbody covers
- Removing and installing short centre underbody cover
- Removing and installing centre underbody cover – e-Golf
- Removing and installing rear underbody cover – petrol/diesel
- Removing and installing rear underbody cover – e-Golf
- Removing and installing front tunnel cross-piece
- Removing and installing rear tunnel cross-piece
Assembly overview - skid plate
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
1 -
Underride guard
Removing
...
Assembly overview – underbody covers, petrol/diesel
1 -
Front cover
Left and right
Removing and installing
→ Chapter
2 -
Underbody cover
Left and right
Removing and ...
Other materials:
Removing and installing electronically controlled damping control unit
-J250-, saloon
Special tools and workshop equipment
required
Vehicle diagnostic tester
Removing
Location: electronically controlled damping control unit
-J250- is installed behind left luggage compartment s ...
Removing and installing accelerator module -GX2-
Removing
–
Fold floor covering -1-
forwards in -direction of arrow-.
–
Release and pull off connector -2-
...
Saw-tooth wear
Saw-tooth wear is a stepped wear pattern on the individual
tread blocks → Fig.
that can cause increased tyre noise. The saw tooth is caused by
uneven deformation of the tread blocks in the tyre's contact
patch. Saw-tooth wear is more pronounce ...
