1 - | Noise insulation |
2 - | Front underbody cover |
3 - | Centre underbody cover |
4 - | Rear underbody cover |
5 - | Bolt |
For rear underbody cover |
6 - | Hexagon nut |
For rear underbody cover |
7 - | Bolt |
For centre underbody cover |
8 - | Hexagon nut |
For centre underbody cover |
9 - | Bolt |
For front underbody cover |
10 - | Hexagon nut |
For front underbody cover |
11 - | Caps |
12 - | Bolt |
For bracket |
13 - | Bracket |
14 - | Bolt |
For noise insulation |
Run-flat tyres, PAX, checking
When checking a tyre, look out especially for the following
criteria:
Surface erosion or ripples on the inner side (inflation
pressure was too low or not sufficient for the load)
...
Removing and installing cylinder head
Special tools and workshop equipment
required
Socket -3410-
Removing
Note
Fit all heat shield sleeves in the same place when
installing. ...
Removing and installing fuel gauge sender -G-, vehicles with front-wheel
drive
Removing
–
Remove fuel delivery unit
→ Chapter.
–
Note colour assignment of cables -1-
for re-installation.
– ...