Volkswagen Golf Service & Repair Manual: Entry and start authorisation system
- Overview of fitting locations - entry and start authorisation system, LHD vehicles
- Overview of fitting locations - entry and start authorisation system, RHD vehicles
- Overview of fitting locations - front keyless entry system, LHD vehicles
- Overview of fitting locations - rear keyless entry system, LHD vehicles
- Overview of fitting locations - front keyless entry system, RHD vehicles
- Overview of fitting locations - rear keyless entry system, RHD vehicles
- Removing and installing interface for entry and start authorisation system -J965-
- Removing and installing interior aerial 1 for entry and start authorisation -R138-
- Removing and installing luggage compartment aerial for entry and start system -R137-
- Removing and installing rear bumper aerial for entry and start system -R136-
Removing and installing bulb for number plate light -X4-/-X5-
Note
If an LED number plate light is faulty, the entire number
plate light must be renewed.
Removing:
– ...
Overview of fitting locations - entry and start authorisation system, LHD
vehicles
1 -
Immobiliser reader coil -D2-
Removing and installing
→ Chapter
2 -
Control unit for electronic steering column ...
Other materials:
Removing and installing poly V-belt pulley with freewheel, manufacturer:
Valeo
Special tools and workshop equipment
required
Multipoint adapter -3400-
Torque wrench -V.A.G 1332-
...
Removing and installing camshaft control valve 1 -N205- and exhaust camshaft
control valve 1 -N318-
Note
On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only
camshaft control valve 1 -N205- is installed.
Removing
Inlet camshaft control valve 1 -N205-
–
Disconnect ele ...
Overview of fitting locations – controls in centre console
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Starter button -E378-
Removing and installing
→ Chapter
2 -
Switch mod ...
